Crown MA 5002VZ

Crown MA-5002VZ Crown MA-5002VZ Description: The Macro-Tech and Maro-Tech 02 Series - high technology amplifiers designed specifically for professional sound reinforcement. MA Series amps provide enormous power in a low-profile design. All Macro-Tech Series amplifiers features PIP (Programmable Input Processor) technology, IOC (Input/Output Comparator) circuitry, Output Device Emulation Protection Circuitry (ODEP) and a Three-year, No-Fault, fully transferable Warranty. The following applies to 120-VAC, 60-Hz units in Stereo mode with 8-ohm loads and an input sensitivity of 26-dB gain unless otherwise specified. Specifications for units supplied outside the U.S.A. may vary slightly at different AC voltages and frequencies. Power Load Impedance: Safe with all types of loads. Rated for 2 to 8 ohms in Stereo, 4 to 16 ohms in Bridge-Mono and 1 to 4 ohms in Parallel-mono mode. Voltage Gain to 1-kHz, 8-ohm rated output; 132:1 6% or 42 dB 1 dB gain at 0.775-volt sensitivity. 71:1 12% or 37 dB 1 dB gain at 1.4-volt sensitivity. 20:1 3% or 26 dB 0.25 dB gain at the 26-dB gain setting. Required AC Mains: 50 or 60 Hz; 100-, 120-, 200-, 208-, 230-, 240-VAC (10%). AC Line Current, Current, voltage and frequency requirements are provided on the units back panel. At Idle: All units draw 90 watts or less. AC Line Connector: 10 AWG cordset with NEMA TT30P plug is provided on 120 VAC, 60 Hz North American units. Crown MA-5002VZ Features: Performance Frequency Response: 0.1 dB from 20 Hz to 20 kHz at 1 watt. Phase Response: 10 degrees from 10 Hz to 20 kHz at 1 watt. Signal-to-Noise Ratio, A-weighted: Better than 105 dB below rated 1-kHz power. Total Harmonic Distortion (THD): 1-kHz rated power, 0.05% or less true THD. Intermodulation Distortion (IMD): (60 Hz and 7 kHz at 4:1) Less than 0.05% from rated power to 35 dB below rated power at 8 ohms. Damping Factor: Greater than 1, 000 from 10 Hz to 400 Hz. Controlled Slew Rate: (Slew rates are limited to useful levels for ultrasonic/RF protection.) Greater than 30 volts per microsecond. Controls Compressor: A three-position back-panel switch is used to control each channels input compressor. The "fast" setting provides an attack time of 4 milliseconds and a release time of 300 milliseconds; the "slow" setting provides an attack time of 12 milliseconds and a release time of 600 milliseconds; the "off" setting defeats output-driven compression. Enable: A front-panel push button used to turn the amplifier on and off. Input Ground Lift: A two-position back-panel switch located on the PIP2-FXQ used to isolate the input audio signal grounds from the AC (chassis) ground. Level: A front-panel rotary potentiometer for each channel with 31 detents used to control the output level. Loudspeaker Offset Integration: A two-position back-panel switch for each channel used to turn the loudspeaker protection circuitry on and off. The circuitry protects against DC, off-center woofer cone movement, and unwanted subsonic and ultrasonic